Make your own goods
in three hours
Make the model you want, such as "a paw keyring with my name on it". Print it on a 3D printer and take the finished piece home. No experience needed.
The class is taught in English.
Usually starts at 13:00 on Saturdays and 12:00 on Sundays. Times can differ by date; the exact time is shown on each date in the calendar. Laptops are provided. You are welcome to bring your own.
Open your booking with the email address you used.
Good for
A different kind of date
Three hours of making something together and taking it home. Make one for each other and swap.
Pre-concert cheer goods
We are right next to Gocheok Sky Dome. Stop by before the show and make a one-of-a-kind piece in your cheer colors with your own words.
First time 3D printing
No design software to learn. Just describe what you want to AI. Laptops are ready, so sit down and start. You will finish even if it is your first time.
If you are here for a concert
- We are right next to Gocheok Sky Dome. The class starts five hours before the show and ends two hours before it, so you can go straight to the entry line.
- If your print is not done before the show, we leave the finished piece at our door. Pick it up after the show.
- Choose a filament in your cheer color and add your own words.
What you make
Pick one piece you want to make, such as a keyring or a keycap, and make it yourself. Choose an open date on the calendar below.
Your own goods
Pick one small piece that fits in your palm, such as a keyring, a keycap, a badge, a small figure or a phone stand, then design it with AI and print it yourself. Add text or a drawing to make it yours and choose the filament color.
Book
Pick an available date and pay. Your booking is confirmed right away. The confirmation email has a link to your booking, where you can cancel.
Pick a date on the calendar.
/class/en
What happens
Usually starts at 13:00 on Saturdays and 12:00 on Sundays, then runs three hours like this. The exact start time is shown on each date in the calendar.
- 0:00
Start
See how 3D printing works and look at what we make today. Something that fits in your palm.
- 0:30
Design
Describe what you want to AI and you get a 3D model. Change the text, drawings, and shapes until you like it. Usually about an hour, up to two if you keep refining.
- 1:30
Prepare
Slice the model, check the print time, and load it onto the printer. Pick a filament color.
- 2:00
Print
While it prints, learn how to finish the surface. Take it off the bed yourself when it is done.
- 3:00
Done
If the print is done, clean it up and take it home. If not, we ship it to you once it is finished.
The space
The class takes place in this room, and you print on the 3D printers right next to it.
Cancellation and refunds
- Bookings close two days before the class. You cannot book the day before or on the day.
- Full refund up to two days before the class.
- No cancellation or refund on the day before or the day of the class.
- If we cannot hold the class, you get a full refund or a new date of your choice.
Want to move your date or have a question about the class? Send us a message.
Contact usGetting here
Right next to Gocheok Sky Dome, in the Saenggak Gongjang Guro building.